Balancing lake
A balancing lake (also flood basin or Sustainable urban drainage scheme) is a term used in the U.K. describing a retention basin used to control flooding by temporarily storing flood waters.[1]: Glossary The term balancing pond is also used, though typically for smaller storage facilities for streams and brooks. In open countryside, heavy rainfall soaks into the ground and is released relatively slowly into watercourses (ditches, streams, rivers). In an urban area, the extent of hard surfaces (roofs, roads) means that the rainfall is dumped immediately into the drainage system. If left unchecked, this will cause widespread flooding downstream. The function of a balancing lake is to contain this surge and release it slowly.[1]: Part E Failure to do this, especially in older settlements without separate storm sewers and foul sewers, can cause serious pollution as well as flooding. EngineeringAt its simplest, a balancing lake can be constructed by creating a dam across a drain or stream at a convenient valley, with a restricted diameter outlet pipe through the dam. Normal flows pass through the pipe without restriction, while heavy flows create a backup, causing water levels behind the dam to rise. Over the following few days, the level subsides. This is often enough for a small housing development. More advanced systems are computer-controlled such that the entire flow of a river can be diverted into a holding lake, perhaps to reduce the impact of a large scale rainstorm in the catchment on communities downriver. For aesthetic and safety reasons, the system can be designed so that there is a permanent lake. A lake with an equivalent area of 1,000 by 1,000 metres will hold a million cubic metres of water for each metre of depth. Typically such a lake would have an outer earth bank of 1 metre, then a leisure path, then a 10 cm inner bank to the steady-state level. Other benefitsA permanent lake can provide useful recreation facilities such as sailing, windsurfing, or of wildlife.[2] Water sports and wildlife habitats do not mix well, though a scheme can have both in linked basins where the recreational basin fills first and the wildlife basin is only used in exceptional conditions.
Case study: Willen Lake, Milton KeynesWillen Lake (52°03′25″N 0°43′10″W / 52.05694°N 0.71944°W) is one of the largest (400,000 m2) purpose-built stormwater balancing lakes in the UK. The lake is designed to take surface run-off from Milton Keynes, the largest of a number designed to do so. The lake has capacity for an additional level increase of 1.3 metres, equivalent to a once in 200 years event. Unlike most of the rest of the UK, the city has separate storm and foul sewers, so sewage pollution is not a significant problem. Additionally, there are facilities to prevent accidental oil spills and the like from reaching the lake. As well as local storm drains, the lake's primary purpose is to intercept the river Ouzel, a tributary of the river Great Ouse. The catchment area is Oxford Clay that tends to get saturated easily, so field run-off has always been a problem. The South Basin is designed for recreational use, mainly dinghy sailing and wind surfing, with a circumference path and banks as described above.[3] It is linked to the North (Wildlife) Basin and can be drawn on to manage the level of the latter more finely. The North Basin has a large, undisturbed, central island.[4] The extensive shallows support a good crop of aquatic plants and invertebrates. Very quickly, it became a key wildfowl site. In winter, it attracts up to 2,500 wild birds, with a wide variety of migrating waders in spring and autumn. Common tern, tufted duck, ringed and little ringed plover, common redshank and northern lapwing.[5] Canada geese have become naturalised and they are permanent residents. Both basins have deep ponds to maintain the fish population during droughts. The lake is managed as a public open space, receiving up to a million visits each year. See alsoReferences
Further reading
|